Elevator furniture fit checker

Can this furniture enter and stand inside the elevator?

Before you startMeasure the actual elevator with doors open. Building listings are often not detailed enough.

Step 1

Add your measurements

Check the door opening and all three inside cabin dimensions.

Example numbers are loaded

Replace each example with what you measured. The example result on the right updates as you type.

Measure the furnitureUse the rigid dimensions after removable pieces come off.

Furniture widthcmMeasure the widest rigid side.Furniture depthcmMeasure the deepest rigid side.Furniture heightcmMeasure the tallest rigid side.

Measure the elevatorCheck both the entrance and the inside cabin.

Elevator door widthcmMeasure the narrowest clear opening with the doors fully open.Elevator door heightcmMeasure from finished floor to the lowest door-frame point.Cabin widthcmMeasure the clear inside width.Cabin depthcmMeasure from the inside doors to the rear wall.Cabin heightcmMeasure to the lowest light, rail, or ceiling obstruction.

Measurements stay in this browser and are never sent to analytics.

Example resultNeeds another look

No right-angle orientation fits the entered dimensions

Diagonal entry and turning are not modeled, so building or delivery confirmation is still required.

Change the sample measurements to turn this into your estimate.

Cabin floor: 150 cm x 190 cm
Door opening: 90 cm x 210 cm
Furniture: 220 cm x 96 cm x 82 cm

Proportional planning schematic - verify all dimensions on site.

Before you buy or start work

Confirm elevator weight and booking rules.
Measure protective padding if required.
Check the hallway turn outside the elevator.

Method

What this result assumes

The item is treated as a rigid rectangular box.

The check tests right-angle orientations only and excludes diagonal insertion.

Limitations

What it cannot confirm

Building rules, weight limits, protective padding, and door timing are excluded.

This is a planning estimate, not a building-code, safety, installation, or delivery guarantee.

Confirm product-specific requirements with the manufacturer, installer, retailer, or qualified trade.

Formula 1.0.0Reviewed 2026-07-13General planning assumptions

Read category methodology